daab™

Ispire presents a small revolution in the world of dabbing, a device entirely dedicated to concentrates, with water cooling and zero atomizer! Indeed, it proposes a full glass airpath as well as a banger made of borosilicate glass to enjoy the terps of your most delicate extractions.

The banger is heated by induction, allowing a stable, homogeneous and clean temperature rise, your extractions never being in contact with any heating element. Unbeatable flavors and easy cleaning in perspective..

Characteristics :

• Manufacturer: Ispire;
• Materials: borosilicate glass, silicone... 
• Dimensions: 9.75 × 3.5 × 2.25 in;
• Works with concentrates of all viscosities and textures;
• Multiple safeguards (heat, overvoltage, batteries) for better reliability and life span ;
• Temperatures: 120 → 425 °C (250 → 800 °F);
• Batteries: 2 x 18650 included (recommended: 3000 mAh → 3500 mAh 30A with minimum 15A of CDR, amperage capacity or continuous discharge rate) ;
• Charging: fast USB-C, usable while charging;
• Activation modes: manual and automatic ;
• Charging voltage: 5 V - 2 A =;
• Refreshment: hydraulic, 18 mL recommended;
• Reclaim recovery via a dedicated bowl (see diagram).

Buy purchasing a daab™ you'll get:

• 1 x daab™ device;
• 1 x water chamber and carrier cup;
• 1 x reclaim cup ;
• 1 x carb cap;
• 2 x inner cups;
• 2 x 18650 batteries;
• 1 x USB-C cable;
• 1 x user manual ;
• 1 x high temp silicone O-ring ;
• 1 x dab pad
• 1 x dabber (?) ;
• 1 x dabber (stirring tool) ;
• 3 x alcohol wipes ;
• 2 x alcohol wipes;
• 1 x silicone water chamber protector.

How the daab™ works:

1. Assemble the device: insert the innercup into thecarrier cup;
2. Fill the water chamber through the mouthpiece of the water chamber, up to the demarcation line;
3. Turn on the device by pressing the power button five times. We recommend starting with a temperature of 435 °F and then adjusting to your preferred temperature. The indicator light in the base will then flash red until the internal bowl temperature is stable. When the induction heating is in effect, the light will flash orange until the temperature is reached.
4. Set the temperature: use the + and - buttons to adjust the heating. Start low, between 400 and 500 °F.
   Low 250 → 445 °F;
   Medium 445 → 600 °F;
   High 600 → 800 °F.
5. Heat: Press the power button twice to start the automatic heating mode. Press again to stop.
6. Wait: The orange light in the water chamber flashes during the heat up process. When the temperature is reached, the light stays on and the unit beeps three times. For a flavor that better respects the terpene profile of your extractions, you can make a "cold dab start" by placing a little bit of concentrate (about a grain of rice) in the borosilicate glass bowl before starting the heating.
7. Enjoy: start inhaling when you want during the heating. Cover the carrier cup with the carb cap for denser and more intense puffs. Inhale slowly so as not to suck your concentrates into the water chamber.
8. Relaunch a warm-up you can start a new heating less than three minutes after the previous one. If you still have reclaim to vaporize, you can reheat the bowl by holding down the power button for 15 seconds. Reheating while the inner cup is still warm will result in overheating your extractions. You can use the supplied replacement inner cup while the previous one cools on a heat-resistant surface before cleaning and using it again.

ℹ️ It is highly recommended to clean the induction area after each use.

The different error messages:

	Sensor error.
	Current above 16 A.
	Battery below 5%, display flashes five times.
	No battery, charge or install a battery. The pictogram flashes for ten seconds.
	Pressing the activation button without a cup inserted in the induction zone will cause the LED indicator to flash red.
	The unit is too hot to operate. Please let it cool down for five minutes.

Product sheet is being finished.

⚠️ As the glass is not guaranteed, we invite you to shake your package before signing for it and to sign with reservation in case of doubt. In case of broken glass upon receipt, you have one hour to report it to us, otherwise no request can be accepted.